Tecfluid MX4 For FLOMID Series Manuel d'utilisateur télécharger pdf (Page 12)

5 MOUNTING

5.1 Parallelism

The maximum parallelism error must be less than 0.5 mm (Lmax—Lmin ≤ 0.5 mm).

5.2 Gasket position

For the wafer mounted sensors, in order to avoid leakage into the inside of the sensor one

must make sure that the rubber gasket (A) of the figure below is fitted into the stainless

steel ring so that it will be pressed directly on the plastic liner.

If the rubber gasket seals against the stainless steel ring then the liquid pressure will force

liquid into the interior of the sensor causing irreparable damage.

The standard material for the supplied gasket is NBR.

The sensors with connections different to wafer are supplied without gaskets.

INSTALLATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Rosman Mohamed 12 Jul 2024 | 01:50:59

thank you

Tecfluid MX4 For FLOMID Series Manuel d'utilisateur Page 12